CAMERON Liquid Turbine Meters
NuFlo turbine flowmeters indicate flow rate and measure total throughput of a liquid line. As liquid flows through the meter and over the rotor, the rotor turns at a speed that is directly proportional to the flow rate. A magnetic pickup senses the rotor blades as they pass and generates an electrical (sine wave) signal. These electrical pulses are then transmitted to the flow measurement readout equipment.
Downloads: Brochure | Manual
In 1957, this flow meter was developed with a tungsten-carbide shaft and bearing to withstand the rugged conditions of the oil field. Over the years, it
has earned an unsurpassed reputation for withstanding severe punishment while maintaining operational and measurement integrity. Today, it remains
a strong seller among Cameron’s NUFLO? liquid measurement products.
NUFLO turbine flow meters indicate flow rate and measure total throughput of a liquid line. As liquid flows through the meter and over the rotor,
the rotor turns at a speed that is directly proportional to the flow rate. A magnetic pickup senses the rotor blades as they pass and generates an
electrical (sine wave) signal. These electrical pulses are then transmitted to the flow measurement readout equipment.
Benefits
Accurate and repeatable measurement
An economical solution for turbine flow meter
applications
Easy installation and a variety of end
connections
Minimum maintenance required
Long service life even in severe applications
Applications
Cameron offers turbine flow meters in a variety of end connections and accuracy levels. Typical applications are:
- Water-injection measurement
- Heater treaters
- Test and production separators
- Disposal wells
- CO2
injection
- Steam generator fuel and feed water
- Metering liquid fertilizer
- Water, fuel and chemical measurement in plant settings
- Chemical tank loading and unloading
- Measuring liquid propane
- In-situ mining and leaching
Accuracy
Cameron offers two meter grades to satisfy various linearity requirements. The standard grade meter is a cost-effective solution for applications requiring accuracy of 1% or less.For higher accuracy, an industrial grade meter can be used. Greater accuracy may be achieved if the expected flow range is specified.
End Connections
NUFLO flow meters are available in a variety of end
connections:
- Threaded
- Grooved
- Flanged
- EZ-IN
- WECO 1502
Threaded (NPT) End Connections
- Threaded meter sizes range from 3/8” to 2”.
- Meter sizes from 3/8” to 1” pipe all have 1” NPT end
connections to simplify meter size changes.
- All meter sizes other than the 2” have male threads.
